28th June 2017

Classic Mini Jet Black Restoration

Mini Underside Stone chipped

ok , last few weeks i have finished the underside , and ran fuel and brake lines, Fitted rear subframe , and I have now rolled car back over again.

Floor , Welding

Front End Done and Car Rolled onto Side

Ok front end is now all fitted , if you want to catch up please check out the video section at top. We have now rolled the car onto the side and started finishing off the small holes that i could not get to while inside the car. Etch primer now going on , and […]

Floor , Front End , Welding

Floor Complete

Sorry for the lack of website updates, you can find all my daily updates on youtube , please check out the videos page. for now , the floor is 99% complete and solid , all door posts have been replaced , as well as part of rear boot , and rear panel / lower rear […]

Floor , Rear End , Welding

Drivers Floor Pan – Complete ish

Ok , drivers floor pan 95% done , seam welded up the tunnel , then plug welded either end. Also spot welded along door step Started re-building the panels around the rear sub frame mount and rear arch , please check YouTube channel for videos / or videos page.

Floor , Rear End , Welding

Drivers Floor Pan Pt4

ok , finally got the drivers floor tacked in . and looks pretty straight so far ,was worried about distortion / twists etc but tried to make the fit snug without beating things with hammer to much , but i guess i will have to wait till its fully welded before checking. Had a bit […]

Floor , Welding

Drivers Floor Pan Pt3

Just a hour or so last night , not sure if people want me to do updates as often as possible, or just wait till a big chunk of work has been done , i do like more updates myself when i read builds ..anyway , Trim the repair panel for the rear heal board […]

Floor , Welding

Drivers Floor Pan Pt2

Ok got floor more trimmed up last night , also repaired bottom edge of bulkhead that wraps under the floor , will clean up and finish welding underside when i roll car over ( well that’s the plan later to finish underside) also started to make the rear heal board ( if that’s its name […]

Floor , Welding

Drivers Floor Pan Pt1

This weekend ( well only sunday ) i spent attacking the drivers floor , first i tried removing the rear pocket as best i could , but then gave up and cut it out ! , it is repairable .. but might look to see how much they are… I have cut away nearly all […]

Floor , Welding

Subscribe

Recent Comments